Tile and Marble Setters

Cut and shape tile to fit around obstacles and into odd spaces and corners, using hand and power cutting tools.

Lay and set mosaic tiles to create decorative wall, mural, and floor designs.

Align and straighten tile using levels, squares, and straightedges.

Prepare cost and labor estimates, based on calculations of time and materials needed for project.

Determine and implement the best layout to achieve a desired pattern.

Measure and mark surfaces to be tiled, following blueprints.

Finish and dress the joints and wipe excess grout from between tiles, using damp sponge.

Study blueprints and examine surface to be covered to determine amount of material needed.

Cut, surface, polish, and install marble and granite or install pre-cast terrazzo, granite or marble units.

Mix, apply, and spread plaster, concrete, mortar, cement, mastic, glue or other adhesives to form a bed for the tiles, using brush, trowel and screed.

Apply mortar to tile back, position the tile, and press or tap with trowel handle to affix tile to base.

Level concrete and allow to dry.

Spread mastic or other adhesive base on roof deck to form base for promenade tile, using serrated spreader.

Cut tile backing to required size, using shears.

Prepare surfaces for tiling by attaching lath or waterproof paper, or by applying a cement mortar coat to a metal screen.

Mix and apply mortar or cement to edges and ends of drain tiles to seal halves and joints.

Remove and replace cracked or damaged tile.

Install and anchor fixtures in designated positions, using hand tools.

Apply a sealer to make grout stain- and water-resistant.

Assist customers in selection of tile and grout.

Select and order tile and other items to be installed, such as bathroom accessories, walls, panels, and cabinets, according to specifications.

Remove any old tile, grout and adhesive using chisels and scrapers and clean the surface carefully.

Measure and cut metal lath to size for walls and ceilings, using tin snips.

Build underbeds and install anchor bolts, wires, and brackets.

Brush glue onto manila paper on which design has been drawn and position tiles, finished side down, onto paper.